Power shut off tools Wrench EYFLA6J / EYFLA6B

Product Description

Power shut off tools Wrench EYFLA6J / EYFLA6B / EYFLA6JR

		Cordless Mechanical Pulse Tool
Type		EYFLA6J / EYFLA6JR	EYFLA6B
Chuck Size		12.7mm Square Drive Pin-hole type	12.7mm Square Drive Ball type
Application		M8 bolt (Tensile bolt) M10 bolt (Normal bolt)
Maximum torque (F mode, fastening 3 sec.)		approx. 120 Nm (M14 bolt)
Torque control function operating range		approx. 653 Nm
Torque Setting		30 stage + F (without torque setting mode)
Flush Detection Mode Applications		L1: For lighter loads during fastener run down L2: For prevailing torque during run down and varying joint rate applications
No load speed (unit : rpm)		0 ~ 2300
Impact per minute		0 ~ 3000
Weight*1 (inc. battery)	EYFB30B	approx. 1.4kg
	EYFB32B	approx. 1.25kg
	EYFB40B
	EYFB41B
Size	Length	172mm
	Height	248mm (EYFB30B), 231mm (EYFB32B)
	Width	approx. 59mm (Width of battery pack: approx. 75mm)
Function	Wireless Communication	EYFLA6JR only with assembly qualifier (OK fastening: Green lamp, NOK fastening: Red lamp)	--
	LED Light	X (ON/OFF switch, Light off after five minutes automatically)
	Tightening confirmation lamp	X (OK fastening: Green lamp, NOK fastening: Red lamp)
	Retightening Prevention Function	X (Possible to set between 0 ~ 3sec.. 0.1 sec. per stage)
	Battery indication lamp	X (3 stage)
	Auto-Power Stop function	X
Application Capacity/ Working Speed		approx. 500 pcs/pack approx. 0.9 sec/1pcs (EYFB30B) approx. 330 pcs/pack approx. 0.9 sec/1pcs (EYFB32B) <M10: 43 Nm, Stage: 23>
Charging time		Usable charge: approx. 35 min. Full charge: approx. 45 min (Battery pack EYFB30B, Charger EY0L82B) Usable Charge: approx. 35 min. Full Charge: approx. 40 min (Battery Pack EYFB32B, Charger EY0L82B)

Notes:
*1 Weights are described in 0.05kg increment.
There are models limited to particular region.
Battery pack is not included.

Accessories

Assembly Qualifier EYFR02B

The Panasonic EYFR02B is a single tool controller for communicating to Panasonics wireless assembly tools. The simple design provides the operator a clear visual and audio feedback, informing the operator of a pass or fail fastening strategy. Connecting the I/O to line stops or a PLC enables additional error proofing capabilities; reducing defects, increasing overall productivity and product quality which leads to a money savings.